N.B.: Use no clean flux dispensing pen to help solder stick, if needed A lot of movement after placement may cause a bad connection.Carefully drop the sensor into the appropriate location. Make sure not to use too much solder to make a connection between two contacts.Method 2: Apply solder directly onto sensors or onto board.Carefully remove the sensor from the template, making sure to keep the solder attached, and drop in the appropriate location.Use edge of tweezers to press the solder onto the contacts.Line up contacts with holes, hold the template firmly in place with tweezers, apply liberal amount of solder.Method 1: Use plastic template to line up solder onto the sensors (can do multiple at a time).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |